Parameters; Parameter List - Mitsubishi Electric MR-JE-C Series Instruction Manual

5. PARAMETERS

5. PARAMETERS
CAUTION

5.1 Parameter list

5.1.1 Extension setting parameters ([Pr. PC_ _ ])
No. Symbol
PC01 STA JOG operation acceleration time constant
Acceleration time constant 1
PC02 STB JOG operation deceleration time constant
Deceleration time constant 1
PC03 STC S-pattern acceleration/deceleration time constant
PC04 TQC Torque command time constant
PC05 SC1 Automatic operation speed 1
PC06 SC2 Automatic operation speed 2
PC07 SC3 Manual operation speed 1
PC08 SC4 Manual operation speed 2
PC09 SC5 Internal speed command 5
Internal speed limit 5
PC10 SC6 Internal speed command 6
Internal speed limit 6
PC11 SC7 Internal speed command 7
Internal speed limit 7
PC12 VCM Analog speed command - Maximum speed
Analog speed limit - Maximum speed
Never make a drastic adjustment or change to the parameter values as doing so
will make the operation unstable.
Do not change the parameter settings as described below. Doing so may cause
an unexpected condition, such as failing to start up the servo amplifier.
Changing the values of the parameters for manufacturer setting
Setting a value out of the range
Changing the fixed values in the digits of a parameter
When you write parameters with the controller, make sure that the identification
No. of the servo amplifier is set correctly. Otherwise, the parameter settings of
another identification No. may be written, possibly causing the servo amplifier to
be an unexpected condition.
POINT
To enable a parameter whose symbol is preceded by *, cycle the power after
setting it. However, the time will be longer depending on a setting value of [Pr.
PF25 Instantaneous power failure tough drive - Detection time] when
"instantaneous power failure tough drive selection" is enabled in [Pr. PA20].
POINT
The following parameters can be used only for Modbus RTU communication.
[Pr. PC70 Modbus RTU communication station number setting]
[Pr. PC71 Function selection C-F]
[Pr. PC72 Function selection C-G]
Name
5 - 1
Initial
Unit
value
0 [ms]
0 [ms]
0 [ms]
0 [ms]
0 [ms]
0 [ms]
100.00 [r/min]
500.00 [r/min]
1000.00 [r/min]
200.00 [r/min]
300.00 [r/min]
500.00 [r/min]
800.00 [r/min]
0.00 [r/min]