Mitsubishi Electric MR-JE-C Series Instruction Manual page 69

5. PARAMETERS
No./symbol/ Setting
name digit
PN19 Set the 1st octet of the default gateway in decimal.
*DGW1 Set the default gateway assigned by the network administrator.
Default The default gateway can also be changed simultaneously by the SLMP command
gateway (IPAdressSet).
setting 1
This parameter cannot be used when Modbus RTU is set.
Setting range: 0 to 255
PN20 Set the 2nd octet of the default gateway in decimal.
*DGW2 Set the default gateway assigned by the network administrator.
Default The default gateway can also be changed simultaneously by the SLMP command
gateway (IPAdressSet).
setting 2
This parameter cannot be used when Modbus RTU is set.
Setting range 0 to 255
PN21 Set the 3rd octet of the default gateway in decimal.
*DGW3 Set the default gateway assigned by the network administrator.
Default The default gateway can also be changed simultaneously by the SLMP command
gateway (IPAdressSet).
setting 3
This parameter cannot be used when Modbus RTU is set.
Setting range: 0 to 255
PN22 Set the 4th octet of the default gateway in decimal.
*DGW4 Set the default gateway assigned by the network administrator.
Default The default gateway can also be changed simultaneously by the SLMP command
gateway (IPAdressSet).
setting 4
This parameter cannot be used when Modbus RTU is set.
Setting range: 0 to 255
PN23 Set the time interval between the transmissions of the alive check message (Keep
Alive ACK) for TCP communication.
*KAA
If no response to the alive check message is received, the connection is forcibly
KeepAlive
closed after the time (setting value × 8 times) has elapsed. In the initial setting, the
time
connection is closed after 8 hours (3600 [s] × 8 times = 28800 [s]) have elapsed.
This parameter can be used only when Modbus/TCP is set.
Setting range: 1 to 7200
PN24 Set the 1st octet of the IP address of the network device allowed to be connected in
decimal.
*IPAF1
When [Pr. PN24] to [Pr. PN27] are all set to "0", the IP address filtering function is
IP address
disabled.
filter 1
This parameter cannot be used when Modbus RTU is set.
Setting range: 0 to 255
PN25 Set the 2nd octet of the IP address of the network device allowed to be connected in
decimal.
*IPAF2
When [Pr. PN24] to [Pr. PN27] are all set to "0", the IP address filtering function is
IP address
disabled.
filter 2
This parameter cannot be used when Modbus RTU is set.
Setting range: 0 to 255
PN26 Set the 3rd octet of the IP address of the network device allowed to be connected in
decimal.
*IPAF3
When [Pr. PN24] to [Pr. PN27] are all set to "0", the IP address filtering function is
IP address
disabled.
filter 3
This parameter cannot be used when Modbus RTU is set.
Setting range: 0 to 255
Function
5 - 10
Initial
value
[unit]
192
168
3
1
3600
[s]
0
0
0