Mitsubishi Electric MR-JE-C Series Instruction Manual page 68

5. PARAMETERS
No./symbol/ Setting
name digit
PN12 Set the 2nd octet of the IP address in decimal.
*IPAD2 Set the IP address assigned by the network administrator.
IP address When SLMP command (IPAdressSet) is received, the setting of the second octet is
setting 2 written to this parameter.
Refer to table 5.1 for the relation between the setting value of the identification
number setting rotary switch and the parameter setting value.
This parameter cannot be used when Modbus RTU is set.
Setting range: 0 to 255
PN13 Set the 3rd octet of the IP address in decimal.
*IPAD3 Set the IP address assigned by the network administrator.
IP address When SLMP command (IPAdressSet) is received, the setting of the third octet is
setting 3 written to this parameter.
Refer to table 5.1 for the relation between the setting value of the identification
number setting rotary switch and the parameter setting value.
This parameter cannot be used when Modbus RTU is set.
Setting range: 0 to 255
PN14 Set the 4th octet of the IP address in decimal.
*IPAD4 Set the IP address assigned by the network administrator.
IP address When SLMP command (IPAdressSet) is received, the setting of the fourth octet is
setting 4 written to this parameter.
Refer to table 5.1 for the relation between the setting value of the identification
number setting rotary switch and the parameter setting value.
This parameter cannot be used when Modbus RTU is set.
Setting range: 0 to 255
PN15 Set the 1st octet of the subnet mask in decimal.
*SNMK1 Set the subnet mask assigned by the network administrator.
Subnet mask The subnet mask can also be changed simultaneously by the SLMP command
setting 1 (IPAdressSet).
This parameter cannot be used when Modbus RTU is set.
Setting range: 0 to 255
PN16 Set the 2nd octet of the subnet mask in decimal.
*SNMK2 Set the subnet mask assigned by the network administrator.
Subnet mask The subnet mask can also be changed simultaneously by the SLMP command
setting 2 (IPAdressSet).
This parameter cannot be used when Modbus RTU is set.
Setting range: 0 to 255
PN17 Set the 3rd octet of the subnet mask in decimal.
*SNMK3 Set the subnet mask assigned by the network administrator.
Subnet mask The subnet mask can also be changed simultaneously by the SLMP command
setting 3 (IPAdressSet).
This parameter cannot be used when Modbus RTU is set.
Setting range: 0 to 255
PN18 Set the 4th octet of the subnet mask in decimal.
*SNMK4 Set the subnet mask assigned by the network administrator.
Subnet mask The subnet mask can also be changed simultaneously by the SLMP command
setting 4 (IPAdressSet).
This parameter cannot be used when Modbus RTU is set.
Setting range: 0 to 255
Function
5 - 9
Initial
value
[unit]
168
3
0
255
255
255
0