Machine Parameter Editor - HEIDENHAIN iTNC 530 Service Manual

12.5 Machine Parameter Editor


Call the Press the following key combination to call the active machine parameter list:
active machine
parameter list
The active machine parameter list appears on the screen.
The iTNC automatically enters this parameter list into the OEM.SYS under MPFILE = xxxx.
July 2002
 Select Programming and Editing operating mode.

Call input field for code number.
Caution
Machine parameters may only be changed after consultation with the machine
manufacturer.
 Exit the machine parameter mode.
Note
If the message "Line is write-protected" is displayed when trying to edit a machine-
parameter value, the machine parameter list is protected against editing. Contact the
machine manufacturer for more information.

Enter code number and acknowledge.
12 – 207