Table of Contents
Advertisement
End Point (ATV)
The End Point function adjusts the left and right servo
throws, generates differential throws, and will correct
improper linkage settings.
The travel rate (normal full stick movement at high rates)
can be varied from 30% to 140% in each direction on
channels 1 to 16. Also, the limit point (how far the servo
travels when a mix is involved) where servo throw stops
may be varied from 0% to 155%.
● Touch the [End Point (ATV)] button in the Linkage Menu to
call the setup screen shown below.
●Return to Linkage Menu
(The display screen is an example. The screen depends on the model type.)
Servo travel adjustment
1. Touch the travel button of the channel you want
to set. Adjustment buttons appear on the screen.
2. Use these buttons to adjust the rate.
●Initial value: 100%
●Adjustment range: 30%~140%
3. Repeat the procedure above for each rate.
30 ～
140%
Sets the travel, limit point, and speed of
each servo.
30 ～
140%
Note: The indicators on the screen display actual servo throw
of the each channel. The center position of the indicator is
based on the Sub-Trim settings. Therefore the Sub-Trim
adjustment changes the Limit point display of the indicator.
The Servo Speed setting is used to set the servo delay for
each channel, from channel l to channel 16. The system uses
the programmed speed (delay) to slow down servo position
changes. The Servo Speed setting can be varied from 0 to 27
in each channel.
Limit point adjustment
1. Touch the limit button of the channel you want to
set.
2. Use the adjustment buttons to adjust the limit point.
●Initial value: 135%
●Adjustment range: 0%~155%
3. Repeat this procedure for each limit point.
Servo speed setting
1. Touch the Speed button of the channel you want
to set.
2. Use the adjustment buttons to adjust the servo
speed.
●Initial value: 0
●Adjustment range: 0~27 (steps)
3. Repeat this procedure for each channel.
To close this screen, touch the [End Point
(ATV)] button.
＜ Linkage Menu ＞
91
Advertisement
Table of Contents
