End Point - FUTABA 10J Instruction Manual

End point

END POINT
Function
The End Point function adjusts the left and right
servo throws, generates differential throws, and
will correct improper linkage settings.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
● Select the channel with
the Jog key.
＜ ChannelDisplay ＞
ACROBATIC
1: AIL （ Aileron） 6: FLP （ Flap）1: AIL （ Aileron） 6: PIT （ PITCH）1: AIL （ Aileron） 6: FL2 （ Flap2） 1: AIL （ Aileron） 6: AU6
2: ELE （ Elevator）7: AU7
3: THR （ Throttle）8: AU8
4: RUD （Rudder）9: AU9
5: GER （ Gear） 10: AU0
End point
① A channel is chosen by Jog key.
Selection range：1 ∼ 10ch
50
② Select
from the menu with the Jog
（1 second）
（Left ／ Down） （Right ／ Up）
rate display rate display
HELICOPTER
2: ELE （ Elevator）7: AU7
3: THR （ Throttle）8: AU8
4: RUD （Rudder）9: AU9
5: GYR （ GYRO） 10: AU0
② Operate the stick or knob of the selected
channel fully to the left (down) or right (up)
and adjust the rate by pressing the + key or
‒ key.
Adjust the rate of each direction of the stick and VR by repeating step ① .
Servo throw
At 100% setting the servo throw of each channel is about 40°
for channels 1 to 4 and about 55° for channels 5 to 10.
However, the maximum servo travel for channels 5 to 10 is
about 110%.
*When channels 5 to 8 were mixed by flaperon, differential or
ailvator, the throw becomes the same (about 40° ) as channels
1 to 4.
"END POINT"
key.
GLIDER (AF4)
2: ELE （ Elevator）7: AL2 （ Aileron2）2: ELE （ Elevator）7: AU7
3: MOT （ Motor） 8: FL3 （ Flap3） 3: THR （ Throttle）8: AU8
4: RUD （Rudder）9: FL4 （ Flap4） 4: RUD （Rudder）9: AU9
5: FLP （ Flap）
＋ −
or
(Common)
③ Open the setting screen by
pressing the Jog key.
● T h e s e t t i n g r a t e o f e a c h
channel
MULTICOPTER
10: AU0 5: MOD
Range：
0 ∼ 140%
Default：100%
● When you want to
return the set value
to the initial value,
press the + key and ‒
key simultaneously.
10: AU0