Table of Contents
Advertisement
End point
The End point function adjusts the left and right
servo throws, generates differential throws, and will
correct improper linkage settings.
The travel rate (normal full stick movement at high
rates) can be varied from 30% to 140% in each
direction on channels 1 to 16. Also, the limit point
(how far the servo travels when a mix is involved)
where servo throw stops may be varied from 0% to
155%.
● Tap the [End point] button in the
Linkage menu to call the setup
screen shown below.
●Return to
Linkage menu
Servo travel adjustment
1. Tap the travel button of the channel you
want to set. Value input buttons appear on
the screen.
2. Use these buttons to adjust the rate.
●Initial value: 100%
●Adjustment range: 30%~140%
3. Repeat the procedure above for each rate.
Sets the travel, limit point.
Indicates the current
direction of the stick, etc.
(The display screen is an example. The screen depends on the model type.)
Travel rate
Limit point
Left / Top
Right / Bottom
Limit point adjustment
1. Tap the limit button of the channel you want
to set.
2. Use the value input buttons to adjust the limit
point.
●Initial value: 135%
●Adjustment range: 0%~155%
3. Repeat this procedure for each limit point.
70
30 ～
30 ～
140%
140%
Next page
Ch7-16
Tap the values you
wish to adjust and
value input buttons
will appear on-screen.
Advertisement
Table of Contents
