Plc Setup - Omron CP1H-X40D Operation Manual

Startup Settings
Startup Hold Settings
Name
1 Force Status Hold Bit
2 IOM Hold Bit
Startup Data Read Setting
Name
1 Read DM from flash
memory
Mode: CPU Unit Operating Mode
Name
1 Use programming con-
sole (RUN mode)
Note A Programming Console cannot be connected to the CP1H. If the default setting, "Use programming
console," is set, the CPU Unit will start in RUN mode.
Appendix G

PLC Setup

Default Settings
Not held. Not held.
Held.
Not held. Not held.
Held.
Default Settings
Do not read. Do not read.
Read.
Default Settings
Use program- Use programming con-
ming console sole: RUN mode
(RUN mode)
Program: PROGRAM
(See note.)
mode
Monitor: MONITOR
mode
Run: RUN mode
When setting is read Internal
by CPU Unit address
When power is turned 80
ON
When power is turned 80
ON
When setting is read Internal
by CPU Unit address
When power is turned 82
ON
When setting is read Internal
by CPU Unit address
When power is turned 81
ON
Bits Settings
14 0
1
15 0
1
Bits Settings
15 0
1
Bits Settings
00 to 0000 hex
15
8000 hex
8001 hex
8002 hex
739