Omron CP1H-X40D Operation Manual page 480

Temperature Sensor Units
Setting Temperature Ranges
Note
Note
!Caution Set the temperature range according to the type of temperature sensor con-
!Caution Do not set the temperature range to any values other than those for which
446
(1) Always turn OFF the power supply before setting the temperature range.
(2) Never touch the DIP switch or rotary switch during Temperature Sensor
Unit operation. Static electricity may cause operating errors.
The Temperature Sensor Unit's DIP switch and rotary switch are used to set
the temperature unit, to select 2-decimal-place Mode is to be used, and to set
the temperature input range.
DIP Switch
Used to set the temperature
unit and the number of
decimal places used.
DIP Switch Settings
The DIP switch is used to set the temperature unit (°C or °F) and the number
of decimal places used.
ON
1 2
SW1
1 Temperature unit
2 Number of decimal
places used (See note.)
(0.01 expression)
For details on 2-decimal-place Mode, refer to Two-decimal-place Mode on
page 453.
Rotary Switch Setting
nected to the Unit. Temperature data will not be converted correctly if the tem-
perature range does not match the sensor.
temperature ranges are given in the following table. An incorrect setting may
cause operating errors.
The rotary switch is used to set the temperature range.
Rotary Switch
Used to set the
temperature input range.
Temperature input terminals
Setting
°C
OFF
°F
ON
OFF Normal (0 or 1 digit after the decimal
point, depending on the input range)
ON 2-decimal-place Mode
Section 7-5