Figure 189 Setting the LLDP operating mode to Tx
Enable global LLDP:
5.
a. Click the Global Setup tab.
b. Select Enable from the LLDP Enable list.
Click Apply.
6.
A progress dialog box appears.
Click Close on the progress dialog box when the progress dialog box prompts that the
7.
configuration succeeds.
Verifying the configuration
Display the status information of port GigabitEthernet 1/0/1 on Switch A:
1.
a. From the navigation tree, select Network > LLDP.
By default, the Port Setup tab is displayed.
b. Click the GigabitEthernet1/0/1 port name in the port list.
c. Click the Status Information tab at the lower half of the page.
The output shows that port GigabitEthernet 1/0/1 is connected to an MED neighbor device.
Figure 190 The status information tab (1)
Display the status information of port GigabitEthernet 1/0/2 on Switch A:
2.
a. Click the GigabitEthernet1/0/2 port name in the port list.
b. Click the Status Information tab at the lower half of the page.
192