Example; Verifying A Vlan Mac Address Configuration - HP 3500 Series Advanced Traffic Management Manual

Immediately after you configure a VLAN MAC address or remove a
■
configured MAC address, a gratuitous ARP message is broadcast on the
connected segment to announce the change of the IP-to-MAC address
binding to all connected IP-based equipment.
■ A configured VLAN MAC address supports proxy ARP and gracious ARP.
A new MIB variable, ifRcvAddressTable, is introduced to support VLAN
■
MAC configuration.
■ You cannot configure a VLAN MAC address using the WebAgent or menu
interface. You must use the CLI.
■ VRRP is not supported on a VLAN interface with a user-configured MAC
address.

Example

The following example shows how to configure a MAC address on VLAN 101.
HP Switch# configure terminal
HP Switch(config)# vlan 101
HP Switch(vlan-101)# ip-recv-mac-address 0060b0-e9a200
interval 100

Verifying a VLAN MAC Address Configuration

To verify the configuration of Layer 3 MAC addresses on the VLAN interfaces
of a switch, enter the show ip-recv-mac-address command.
HP Switch# show ip-recv-mac-address
VLAN L3-Mac-Address Table
VLAN
-------------
DEFAULT_VLAN
VLAN2
Figure 1-42. Example of Displaying a VLAN MAC Address
Migrating Layer 3 VLANs Using VLAN MAC Configuration
L3-Mac-Address
------------------------
001635-024467
001635-437529
Static Virtual LANs (VLANs)
Timeout
-----------
60
100
1-67