Poe Legacy Enable - HP FlexNetwork NJ5000 User Manual

Views
System view
Default command level
2: System level
Parameters
gigabitethernet interface-number1: Specifies PI 1 by its interface number. Valid interface numbers
are 1/0/3 and 1/0/4.
power1: Specifies the amount of power to be allocated to PI 1. The value range is 1000 mW to 17000
mW.
gigabitethernet interface-number2: Specifies PI 2 by its interface number. Valid interface numbers
are 1/0/3 and 1/0/4. The interface number of PI 2 cannot be the same as that of PI 1.
power2: Specifies the amount of power to be allocated PI 2. The value range is 1000 mW to 17000
mW.
Usage guidelines
The total amount of power allocated to a pair of PIs cannot exceed the maximum allowed power of
the PSE.
Examples
# Forcibly allocate 1000 mW and 2000 mW power to the PIs GigabitEthernet 1/0/3 and
GigabitEthernet 1/0/4, respectively.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] poe force-power GigabitEthernet 1/0/3 1000 GigabitEthernet 1/0/4 2000
Please make sure to remove this configuration before changing your Power source. Continue?
[Y/N]:y

poe legacy enable

Use poe legacy enable to enable the PD compatibility check feature.
Use undo poe legacy enable to disable the PD compatibility check feature.
Syntax
poe legacy enable
undo poe legacy enable
Default
The PD compatibility check feature is disabled.
Views
System view
Default command level
2: System level
Usage guidelines
A PD is standard if it is compliant with IEEE 802.3af or IEEE802.3at. A PD is non-standard if it is not
compliant with either of the standards.
If the PD compatibility check feature is enabled, the device supplies power to both standard and
non-standard PDs. If the feature is disabled, the device supplies power only to standard PDs.
21