Manage-Mode; Poe Force-Power - HP FlexNetwork NJ5000 User Manual

Table 10 Commands for features peculiar to the HPE FlexNetwork NJ5000 5G PoE+ Walljack
Switch
Command
manage-mode on
undo manage-mode on
poe force-power gigabitethernet
interface-number1 power1 gigabitethernet
interface-number2 power2
poe legacy enable
undo poe legacy enable

manage-mode

Use manage-mode on to enable the device to operate in management mode.
Use undo manage-mode on to set the device operating mode to unmanagement.
Syntax
manage-mode on
undo manage-mode on
Default
The HPE NJ5000 5G PoE+ switch operates in management mode.
Views
System view
Default command level
2: System level
Usage guidelines
In management mode, you can assign an IP address to the device. The device is manageable from
the Web interface or CLI.
In unmanagement mode, you can manage the device only from the console port.
Examples
# Enable the device to operate in management mode.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] manage-mode on

poe force-power

Use poe force-power to forcibly allocate power to a pair of PIs.
Use undo poe force-power to remove power allocation to a pair of PIs.
Syntax
poe force-power gigabitethernet interface-number1 power1 gigabitethernet interface-number2
power2
undo poe force-power
Task
Set the device operating mode to management or
unmanagement.
Forcibly allocate power to a pair of PoE interfaces (PIs).
Enable or disable PD compatibility check.
20