p
MASTER CYLINDER
Removal I Installation
BRAKE SYSTEM
1. Remove in the order shown in the figure, referring to Removal Note.
2. Install in the reverse order of .removal, referring to Installation Note.
3. After installation, add brake fluid, bleed air, and check for fluid leakage.
Caution
• Brake fluid will damage painted surfaces. If it does get on a painted surface, wipe it off im-
mediately.
N·m (m·kg, tt·lb)
05UOPX-016
1. Fluid level sensor connector
4. Nut and washer
2. Brake pipe
Removal note ...................................... below
5. Reservoir and master cylinder
Disassembly / Assembly /
3. Connector bolts
9MUOPX-020
P-10
Removal note
Brake pipe
Inspection ................................. page
P-12
Disconnect/connect the brake pipe from/to the master cylin-
der with the SST.