Snap Ring; Piston And Secondary Cup Assembly - Mazda MX-5 1990 Workshop Manual

CLUTCH MASTER CYLINDER
H
9MUOHX-019
9MUOHX-023
Disassembly Note
Snap ring
Note
• Do not damage the push rod contact surface of the
piston.
Press down on the piston and remove the snap ring with snap-
ring pliers.
Piston and secondary cup assembly
Caution
• Hold a rag over the master cylinder to prevent the
piston and secondary cup assembly from jumping
out.
Remove the piston and secondary cup assembly, spacer, and
primary cup by applying compressed air through the clutch
pipe installation hole.
Assembly Note
Caution
• Before assembly, make sure all parts are completely
clean.
• Do not mix different brands of clutch fluid.
• Do not reuse the clutch fluid which was drained out.
• Apply the specified clutch fluid to the piston and
secondary cup assembly, spacer, primary cup, and
cylinder bore before assembly.
• Replace parts with new ones whenever specified to
do so.
9MUOHX-021
Piston and secondary cup assembly
Install the spring, primary cup, spacer, and piston and secon-
dary cup assembly, noting the proper direction of the parts.
(Refer to page H-10.)
Snap ring
Note
• Do not damage the push rod contact surface of the
piston.
While pressing the piston, install the snap ring.
H-11