Mazda MX-5 1990 Workshop Manual page 677

05UOTX·204
05UOTX·205
05UOTX·206
05UOTX·207
HORN
REMOVAL
I INSTALLATION
Horn
Remove and install as shown in the figure.
Horn Switch
U.S. spec.
Warning
T
• Before removal of the air bag module, the negative
battery cable must be disconnected to prevent ac-
cidental deployment of the air bag.
1. Disconnect the negative battery cable.
2. Remove the air bag module, then remove the steering wheel
assembly.
Warning
• When carrying an air bag module, make sure the
trim cover is pointed away from your body to pre-
vent injury in the event of an accidental deployment.
• When placing an air bag module on any surface
place it with the trim cover upward. This will reduce
the motion of the module if it is accidentally
deployed.
3. Before installation of the steering wheel reset the clock spring
connector as follows:
(1) Set the front wheels straight ahead.
(2) Turn the clock spring connector clockwise until it stops.
(3) Return 2.75 turns.
(4) Align the marks (counterclockwise) on the clock spring
connector and the outer hausing.
T-95