Mazda MX-5 1990 Workshop Manual page 434

MANUAL STEERING
N
Removal I Installation
Caution
• Do not remove the steering wheel of air bag equipped models (U.S. spec.) if not necessary .
• Adjust the clockspring connector after installing the combination switch. (U.S. spec.)
(Refer to Section T.)
1. Disconnect the negative battery cable.
2. Remove in the order shown in the figure, referring to
Removal Note.
3. Install in the reverse order of removal.
4. Tighten all necessary nuts and bolts to the specified torque.
5. After installation, check if the horn sounds. If the horn does not sound, remove the air bag module and
connect the module connectors. (Refer to Section
T.)
WITHOUT AIR BAG
®
39-49 (4.0-5.0, 29-36)
CD
10-26
(1.0-2.7, 13-20)
18-26 (1.8_2.7,13_20'\
~
1. Air bag module
~
Removal/Installation ..................... Section T
1. Horn pad (without air bag)
2. Locknut
3. Steering wheel
Removal Note ............................ page N-10
4. Column cover
6
N·m (m-kg, ft-Ib)
05UONX-013
5. Combination switch
Removal/Installation ..................... Section T
6. Lower panel
7. Intermediate shaft bolt
8. Steering shaft
Disassembly / Inspection /
Assembly .................................. page N-10
N-9