Radiator; Removal / Inspection / Installation - Mazda MX-5 1990 Workshop Manual

RADIATOR
E
RADIATOR
REMOVAL I INSPECTION I INSTALLATION
Caution
• Obtain the code number and deactivate the audio anti-theft system before disconnecting the
battery. (Refer to page T -113.)
• Position the hose clamp in the original location on the hose, and squeeze the clamp lightly
with large pliers to ensure a good fit.
1. Disconnect the negative battery cable.
2. Drain the engine coolant.
3. Remove the under cover.
4. Remove in the order shown in the figure.
5. Install in the reverse order of removal.
7.6-11 N·m
(80-110
em-kg,
69-95 In-Ib) .
1 . Radiator hose
2. Coolant reservoir hose
3. Cooling fan connector
05UOEX-017
N·m (m.kg,
ft.lb)
05UOEX-016
4. Cooling fan and additional fan
5. Radiator
Inspection ..................................... page E-7
INSPECTION
Check for the following and repair or replace as necessary.
1. Cracks, damage, and water leakage.
2. Bent fins (repair with a screwdriver).
3. Distorted or bent radiator inlet.
Steps After Installation
1. I nstall the under cover.
2. Fill the radiator with the specified amount and type of en-
gine coolant. (Refer to page E-5.)
3. Connect the negative battery cable.
4. Start the engine and check for leaks.
E-7