Bearing Caps - Mazda MX-5 1990 Workshop Manual

M
HEEL CONTACT
FACE CONTACT
63G09X-386
99U09X-043
'.,.1
05UOMX-120
05UOMX-121
M-42
DIFFERENTIAL
(2) Heel and face contact
Replace the spacer with a thicker one to bring the drive
pinion in.
Bearing caps
1. Tighten the bearing cap bolts.
Tightening torque:
68-89 N·m (6.9-9.1 m-kg, 50-66 ft-Ib)
2. Install the lock plates on the bearing caps.
Tightening torque:
18-25
N·m
(1.8-2.6
m-kg,
13-19
ft-Ib)
Differential case
1. Apply sealant to the housing face.
2. Tighten the bolts.
Tightening torque:
23-26
N·m
(2.3-2.7
m-kg,
10-20
ft-Ib)
Output shaft
Caution
• With viscous L.S.D., the right output shaft is longer
than the left shaft.
1. Install a new clip.
2. Install the output shafts into the side gears by lightly tap-
ping them with a plastic hammer.
3. Verify that the output shafts are hooked into the side gears
by pulling them by hand.