PRIMER
MOLDING AND GARNISH
s
05UOSX-040
05UOSX-041
05UOSX-042
Rear window molding (Detachable hard top)
1. Remove the rear window glass. (Refer to page S-42.)
2. Install the rear window glass. (Refer to page 8-42.)
3. Apply primer with a brush to the bonding area of the new
rear window molding, and allow it to dry for approx. 30
minutes.
Caution
• Keep the area free of dirt and grease. Do not touch
the surface. If primer gets on the hand, remove it
immediately.
4. Install the rear window molding to the glass, as shown.
5. If the molding is too long, cut the excess molding 10mm
(0.39 in) inside the joint molding edge.
Hardening time of repair seal
Temperature
Surface hardening time
Time required until car
can be put into service
5°e (41°F)
Approx.
1.5
hr
12
hr
20°C (68°F)
Approx. 1 hr
4 hr
35°C (95°F)
Approx. 10 min
2 hr
--
6. Check for water leaks. If a leak is found, wipe the water off
well and repeat the installation.
05UOSX-043
S-29