Mazda MX-5 1990 Workshop Manual page 696

T
[
[
[
[
[
[
[
T-114
-,.-
.,
c ..:, -,
-1
05UOTX-334
.-,
,
I
,~
__ .. ]
C C, C, "_
05UOTX-335
-]
05UOTX-246
=,
C L' .-,,]
L _" _
[:]uu
05UOTX-247
=1 ,_ ' _ 1
L • •
~]
{>
- - _I
L L. L.
e]
05UOTX-248
AUDIO
Canceling code number
1. Begin with the audio unit off and the ignition switch in ACC
position (time displayed).
2. Press REW and FF simultaneously for approximately 2 sec-
onds unit CODE is displayed and flashes.
3. Again press REW and FF while CODE is flashing (within
10 seconds). The display will exhibit bars.
4. While the bars are displayed, input the current code num-
ber as described in setting procedure Step 4. (2547, for
example).
•
5. With the code number on the display, press REW and FF
for approximately 2 seconds until a beep is heard and CODE
appears.
After 5 seconds, CODE will disappear and the clock mode
will appear. This indicates the code number is canceled.
Note
• If Err appears on the display, begin from Step 1.
If anti-theft system is activated
Note
• If the anti-theft system is activated, CODE appear
on the display until previous code number is in-
putted.
To deactivable anti-theft system
1. Push REW and FF until bars are displayed.
2. While bars are displayed, input the code number as
described in setting procedure.
3. Push REW and FF approximately 2 seconds until a beep
is heard CODE is and displayed. CODE will flash for 5 sec-
onds then disapears to indicate that the system is operable.
4. If Err (error) appears, try again from Step 1.
Note
• Three consecutive error will activate the anti-theft
system, and the audio unit will be completely in-
operable.
• Have the audio unit changed at listed panasonic
service Co.