Mazda MX-5 1990 Workshop Manual page 462

BRAKE SYSTEM
Removal/Installation
1 . Remove in the order shown in the figure.
2. Install in the reverse order of removal.
3. Take the following steps after installation:
(1)
Check and adjust the push rod and piston clearance. (Refer to page P-11.)
(2) Add fluid and bleed the air. (Refer to page P-6.)
(3) Check all parts for fluid leakage.
(4) Make an on-vehicle check of the unit. (Refer to page P-13.)
(5) Check that the vacuum hose does not contact other parts.
Caution
• Apply grease to the clevis pin .
• Apply sealant to the gasket contact surface.
®
® -
13-22 (1.3-2.2,9.4-16)
1 . Fluid level sensor connector
5. Vacuum hose with check valve
2. Brake pipe 6. Clevis pin
3. Proportioning valve 7. Power brake unit
4. Master cylinder 8. Gasket
p
N·m (m-kg, ft-Ib)
05UOPX-029
P-15