End Plate - Mazda MX-5 1990 Workshop Manual

05UOBX-071
ASSEMBLY
B
3. Install new gaskets onto the oil pump body and the rear
cover with the projections in the notches shown in the figure.
4. Apply a continuous bead of silicone sealant to the oil pan
along the inside of the bolt holes and overlap the ends.
5. Install the oil pan.
Tightening torque:
7.8-11
N·m
(80-110
em-kg,
69-95
in-Ib)
End Plate
1. Install the end plate.
Tightening torque:
7.8-11
N·m
(80-110
em-kg,
69-95
in-Ib)
Flywheel
1. Remove the sealant from the flywheel bolt holes in the crank-
shaft and from the flywheel bolts.
Caution
• If all the previous sealant cannot be removed from
a bolt, replace the bolt.
• Do not apply sealant if a new bolt is used.
2. Set the flywheel onto the crankshaft.
3. Apply sealant to the flywheel bolts and install them.
4. Hold the flywheel with the SST.
5. Tighten the bolts in two or three steps in the order shown.
Tightening torque:
96-103 N·m (9.8-10.5 m-kg, 71-76 ft-Ib)
8-69