Mazda MX-5 1990 Workshop Manual page 62

ENGINE
ENGINE STAND MOUNTING
B
lUI ......... .
05UOBX-086
05UOBX-089
1. Install the SST (arms) to the holes as shown in the figure,
and loosely tighten the SST (bolts)_
2. Assemble the SST (bolts and plate) in the specified po-
sition.
3. Assemble the SST (nuts, hooks, and bolts).
4. Install the SST to the respective arms.
Note
• Adjust the SST (bolts) so that less than 20mm (0.79
in) of thread is exposed.
• Make the SST (plate and arms) parallel by adjust-
ing the SST (bolts and nuts).
5. Tighten the SST (bolts and nuts) to affix the SST firmly.
6. Mount the engine on the SST (engine stand).
8-35