Mazda MX-5 1990 Workshop Manual page 432

49 0118 850C
MANUAL STEERING
N
05UONX-008
05UONX-009
Removal note
Tie-rod end
1) Loosen the tie-rod nut.
2) With the nut protecting the tie-rod end stud, separate the
tie-rod end from the steering knuckle with the SST.
Locknut
Before loosening the locknut from the tie-rod end, make a mark
for reference when tightening.
Tie-rod end boot
Caution
• Do not scar the part where the boot is attached to
the tie-rod end.
Secure the tie-rod end in a vise. Place a chisel against the boot
and hold it at the angle shown_ Remove the boot by tapping
it with a hammer.
Installation note
Tie-rod end boot ,
Put a small amount of grease (lithium base) into the new boot
and set it onto the tie-rod end. Press the boot onto the tie-rod
end with the SST and a press.
N-7