J
FRONT COVER
GASKET
TRANSMISSION CASE
SNAP RING
05UOJX-060
0.
0. . r:0ADJUSTMENT SHIM
ADJUSTMENT SHIM
9MUOJX-110
J-44
TRANSMISSION
•
Adjustment shim
After measuring dimensions (A) and (8) shown in the figure,
use an adjustment shim(s), as specified below, of the thick-
ness corresponding to the value of (A) minus (B), so that bear-
ing end play will be within specification.
Bearing end play: 0-0.1 mm (0-0.004 in)
Adjustment shim thickness:
0.10mm (0.004 in), 0.15mm (0.006 in),
0.30mm (0.012 in)
Release fork
1. Apply Mori white TA No.2 or equivalent organic molybde-
num grease to the shaded areas of the release bearing and
release fork.
2. Install the release bearing and release fork.