Data Change Mode - Ricoh FT556 Service Manual

2. Data Change Mode

1. Follow steps 1-3 of the preceding procedure.
2. Factory setting values or mode will be displayed in the Magnification indicator (three-
digit indicator). (If the data values are not to be changed, turn off DIP SW 201-8.)
3. Enter the desired value or mode using the numeral keys according to the Service
Program Mode table.
4. Turn off DIP SW 201-8.
• The following procedure can also be used to access program numbers 10, 11, 90,
91, and 92 instead of using DIP SW 201-8.
1. Press the Mode Clear key.
2. Press the Clear/Stop key.
3. Press the Enter key; at this time the Copy Counter should blink.
4. Enter the desired number using the numeral keys.
5. Press the Enter key.
• Service program mode is cleared by pressing the Clear Modes key.
2-7