Ricoh FT556 Service Manual page 71

31 March 1987
12. Install the original feed [A] table on the right
side of the belt unit [B] (4 screws with
washers). (Be sure to engage the 2 hooks
[C] of the original table with the docking
holes [D] of the belt unit.)
13. Install the original table cover under the orig-
inal table [E] (4 screws).
14.
Level the DF as follows:
a) Remove the DF grip plate [F] (2 screws).
b) Place 2 sheets of A3 (11" x 17") paper
between the white belt guide spacers
[G] and the exposure glass.
c) Loosen the mounting screws of the right
side magnetic catch [H]. Push down the
right side of the magnetic catch bracket
[I], then tighten the screws of the right
magnetic catch. Repeat this process
with the left side magnetic catch. (Make
sure the magnetic catches are parallel
with the copier top cover.)
d) Remove the 2 sheets of paper.
1-60