Ricoh FT556 Service Manual page 186

1. Rotate the paper size dial to A4. D
move the paper size dial again while perform-
ing this adjustment.
2.
Raise the tray bottom plate [A].
3. Turn off the main switch.
4.
Remove the front
screws).
5.
Loosen the 2 screws securing the pinion
bracket [C].
6. Loosen the screw securing the guide post
lock plate [D].
7. Move the pinion bracket while holding the
pinion so that the pinion does not turn. (The
front and rear guide posts must be equidis-
tant from the center.)
8. Tighten the screws securing the pinion
bracket.
9. Tighten the screws securing the guide post
lock plates.
10. Confirm that the length between the guide
posts [E] is within the standard value range
(297 to 299.5).
11.
Confirm that the side registration is adjust-
ed correctly and reassemble.
n o t
O
inner cover [B] (2
31 March '87
3-57