9. Assemble the pawl shaft assembly and
slide it into the cleaning unit until the shaft
touches the rear side plate.
NOTE: • When installing the cam holder and
the cam rider, align X and Y as
shown in the figure.
• Make sure that the spring end is in
the small hole on the rear side plate.
10. Install the pawl shaft pin.
11. Push the spring collar [A] to the rear and
rotate it one turn as shown in the figure.
Then set the collar on the pin [B].
NOTE: Make sure that the end of the spring is
correctly positioned in the groove of the
collar.
12. Reassemble.
31 March '87
3-13