Table of Contents
Advertisement
8.
Remove the duplex harness hole cap [A]
from the copier left cover.
9.
Slide the duplex
expansion unit. Make sure that the duplex
unit side plates [B] fit to the outside of the
expansion unit rails [C].
When sliding the duplex unit into the ex-
pansion unit, lift the jogger unit by the
sides to prevent the turn guide from
being damaged.
10.
Run the harness [D] into the copier through
the duplex harness hole.
11.
Slide the duplex unit all the way into the
expansion unit.
unit halfway into the
31 March 1987
1-41
Advertisement
Chapters
Table of Contents
