Midi Sorter; Bin Drive Belt Replacement - Ricoh FT556 Service Manual

MIDI SORTER

1. BIN DRIVE BELT REPLACEMENT

When the duplex unit is not installed, it is not
necessary to perform steps 2 to 4.
Note the orientation of the flat surfaces of each
pulley shaft.
1. Remove the sorter front [A] and rear [B]
covers (2 screws each).
2.
Remove the rear cover of the copier (3
screws). Then disconnect the sorter har-
ness (red 2p connector, white 11p connec-
tor, and white 4p connector) and the sorter
ground wire.
3.
Remove the knob screw
duplex unit.
4.
Remove the sorter unit from the machine.
5. Remove the lower cover [D] from the sorter
(2 screws).
[C] from the
3-61