3. TONER SUPPLY CLUTCH DISASSEMBLY
1.
Remove the rear cover (3 screws).
2.
Lower the PCB plate (2 screws).
3.
Disconnect the harness [A] of the bias
power pack (10p connector) and remove
the bias power pack bracket [B] (2 screws
and 1 connector).
4.
Disconnect the cooling blower connector [C]
(2p) and the lens drive motor connector [D]
(6p)
5.
Remove the screw [E] securing the dc har-
ness guide.
6.
Remove the development drive support
bracket [F] (2 screws, 1 E-ring, and 1 bush-
ing).
7.
Remove the toner supply clutch assembly
[G] from the drive shaft while pushing the
main drive chain to the right (1 Allen
screw).
31 March '87
3-9