Ricoh FT556 Service Manual page 33

31 March 1987
15. Install the pick-up roller assembly [A] on the
feed roller shaft.
16. Install the plastic gear [B] on the feed roller
shaft.
17. Reinstall the feed roller [C] (1 snap ring)
and fix the pick-up roller [D] in a raised
position with (shipping) tape [E] as shown.
18. Place the large capacity tray [F] in the cas-
sette holders of either the 3rd or 5th feed
station. (Make sure that the rib of the tray
side plate fits into the groove of the cas-
sette holder.) Then, remove the strip of
tape holding the pick-up roller.
19.
Secure the large capacity tray to the feed
station (2 long screws).
1-22