Installation Procedure - Ricoh FT556 Service Manual

31 March 1987

INSTALLATION PROCEDURE

1. Remove all the external strips of tape
[A].
2. Turn off the main switch of the
and remove the following parts.
Platen cover [B]
Mounting studs (2) [C]
Truss screw [D]
Left scale (2 screws) [E]
Rear cover (3 screws) [F]
Rear upper cover [G]
3. Mount the flip scale [H] on the
exit guide [I] (2 screws). Ensure that the
flip-scale spring [J] is set correctly.
4. Secure the 2 flathead shoulder screws
[K] as shown in the figure.
1-68
copier,
original