Ricoh FT556 Service Manual page 73

31 March 1987
CAUTION: On the following step, avoid bending the
fiber optics sharply; this will damage
the fiber optics.
15. Pass the DF interface harness [A] through
the harness hole [B] of the DF and the
docking hole of [C] the copier.
16. Connect the DF interface harness to the DF
PCB [D] (3 connectors).
NOTE: The fiber optics connectors [E] have differ-
ent colors. Be sure to match these colors
when making these connections.
17. Secure the DF ground wire [F] on the DF
base plate (1
washer).
18. Open the DF and install the nylon harness
bushing [G] from the underside. (This har-
ness bushing should be positioned around
the vinyl tube [H] of the DF harness as
shown.)
1-62
ground screw and star