31 march '87
SERVICE PROGRAM MODE OPERATION
The service program mode is used to (1) check electrical data and (2) change modes or
adjustment values. The factory settings are stored in ROM; other settings are stored in
permanent (battery maintained) RAM.
1.
Data Check Mode
1.
Remove the DIP switch cover on
Copy Counter will start blinking.
2.
Enter the number of the desired
Service Program Mode table.
3.
Press the Enter (#) key.
4.
The appropriate data will be displayed in the Magnification indicator.
5.
After you have finished with the service program mode, turn off DIP SW No. 8.
2-6
the operation panel and turn on DIP SW 201-8. The
SP Mode using the numeral keys according to the