Table of Contents
Advertisement
31 March '87
- Common Procedure for Front and Rear Wire -
NOTE:
The front and rear wires are run in
opposite directions.
1.
Loosen the wire tensioner [A] (1 screw).
2.
Insert the bead [B] (unmarked) into the slot
of the drive pulley [C].
3.
Loop the wire around the drive pulley, as
shown (one and a half turns).
4.
Run the wire over WP1 [D], WP2 [E], WP3
[F], and WP4 [G] in turn while also placing
the lift rods ends in the braces [H].
5.
Insert the bead [I] (red marked) into a slot
of the drive pulley.
6.
Loop the wire around the drive pulley, as
shown (two and a half turns).
7.
Hang the wire on the tensioner pulley [J].
8.
Move the rods up and down manually to
ensure that the drive wire does not overlap
on the pulley.
9.
Tighten the wire using the tensioner (1
screw).
Reassemble.
10.
3-52
Advertisement
Chapters
Table of Contents
