Using Imagedemo To Scan Bar Codes - Symbol PDT 8100 Series Product Reference Manual

PDT 8100 Series with Intel XScale Technology Product Reference Guide
• For terminals with an imager, center the target cross hairs in the center of the
bar code. The entire symbol must be within the brackets. The green scan LED
lights and a beep sounds to indicate a successful decode.
Linear bar code
4. Release the scan trigger.

Using ImageDemo to Scan Bar Codes

1. Ensure the terminal is in scan mode and not image capture mode:
a. Tap Start - ImageDemo.
b. On the Symbol Image Capture screen, tap the Mode menu and select Scan.
Note: ImageDemo modes, including Scan and Capture, are application
dependent.
2. Aim the exit window at the bar code.
3. Tap the Scan button on the terminal's display or press either the right, left, or center
scan trigger. (Center scan triggers vary with keyboard types.)
4. Center the target cross hairs in the center of the bar code. The entire symbol must
be within the brackets (see
sounds to indicate a successful decode.
5. Release the scan trigger.
2-34
Symbol
Aiming Pattern
Figure 2-24. Aiming the Imager
Figure 2-24). The green scan LED lights and a beep
PDF417 symbol