Cleaning The Document Feeder Rollers - Fuji Xerox Versant 80 Press User Manual

21 Maintenance
4
Wipe the document presser (3).
Note
Important • Do not use cleaning agents other than water
5
Hold the green handle to open the chute part,
and wipe the constant velocity transport glass
(4).
Important • Do not use cleaning agents other than water
Note
6
Close the chute part.
7
Lower the document feeder.
21
8
Press the power switch [ ] to switch on the power.
9
Lift and lower the document feeder again.

Cleaning the Document Feeder Rollers

If the document feeder roller is dirty, streaks or smears may appear on copies and document
jams may occur.
To ensure clean copies at all times, clean the document feeder roller about once a month.
Important • Do not use benzene, paint thinner, or other organic solvents. Doing so might damage paint or
1
Pull up the handle of the document feeder top
cover, and open the top cover until it stops.
Note
680
• If dirt does not come off easily, gently wipe it
with a soft cloth moistened with a small
amount of neutral detergent.
or neutral detergent.
or neutral detergent.
• Do not push the constant velocity transport
glass strongly since it is easy to damage the
film around the optical glass surface.
• If dirt does not come off easily, gently wipe it
with a soft cloth moistened with a small
amount of neutral detergent.
coating on plastic parts.
• Cleaning the machine with an excessive amount of water may cause the machine to malfunction or
damage documents during copying or scanning.
• When you fully open the cover, it enters a
fixed position. Open the cover gently.
document presser (3)
Chute
constant velocity
transport glass (4)