Fuji Xerox Versant 80 Press User Manual page 992

23 Appendix
Split Files
You cannot select [Single File for Each Page] when using the Store to Folder or Job Flow
service.
Thumbnail View
FTP Transmission for Scan to PC
23
SMB Transfer for Scan to PC
If you use Mac OS X 10.7 Lion, OS X 10.8 Mountain Lion, or OS X 10.9 Mavericks, contact our
Customer Support Center and ask if your operating system is supported. In passive mode,
the scan service and scanner calibration using the Print Server are not available.
Store to WSD
Note
992
When you use Internet Explorer, even if you click "To delete file, click here." in the
[Document Acquisition] screen of the Store & Send Link service, file deletion may not be
performed. In this case, use another browser than Internet Explorer to delete the file.
Files in a folder may not be displayed in thumbnail view in the following cases. In those
cases, display them in list view.
- Some file is not displayed in thumbnail view even though it is stored in the folder.
- Characters and images are not correctly displayed because they are scaled down from
the actual sizes.
The orientation of an image displayed in thumbnail view depends on which orientation
the document was stored in.
If the power is cut off immediately after a scanned file is stored in a folder, or if the hard
disk space is insufficient to display thumbnails, files in the folder may not be displayed in
thumbnail view. In that case, display them in list view.
By factory default, [Passive Mode] is selected as a transfer mode to send scanned data
via FTP from the machine.
You can switch the FTP transfer mode using CentreWare Internet Services, but cannot
switch the mode per job or per destination FTP server.
Depending on your network environment, operations may not be performed properly
unless the FTP transfer mode is switched from [Passive Mode] to [Active Mode].
When [IP Filtering] is enabled, make sure to switch the FTP transfer mode to [Active
Mode].
In [Passive Mode], the server permits a client to connect to the port for the data transfer
so that the client starts the connection. [Passive Mode] is commonly used and also has
lower security risk than [Active Mode].
In [Active Mode], a client notifies the server of the port number for the data transfer so
that the server starts the connection. [Active Mode] may incur a security risk such as
impersonation by third parties. In addition, the proper connection may not be available
in a firewall environment. In such a case, select [Passive Mode]. In passive mode, the scan
service and scanner calibration using the Print Server are not available.
• WSD stands for Web services on Devices.
When the WSD scan port is not activated, [Store to WSD] button is not displayed in the
Services Home screen. Enable the WSD scan port to use the Store to WSD feature on the
machine.