Fuji Xerox Versant 80 Press User Manual page 842

22 Problem Solving
Error Code
116-211 [Cause]
116-212
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and that the
116-220 [Cause]
[Remedy] Contact our Customer Support Center.
116-310 [Cause]
116-311
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
116-312
116-313
116-314
116-315
116-316
116-317
116-318
116-319
116-321
116-322
116-323
116-324 [Cause]
[Remedy] If an error occurred while printing, turn off the machine once, then turn the machine on
22
116-325
[Cause]
116-328
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
116-329
116-330
116-331
116-332
116-333
116-334
116-336
116-337
116-338
116-339 [Cause]
[Remedy] To use the Job Based Accounting system, the hard disk is required. Switch off the
116-340 [Cause]
116-341
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
116-342 [Cause]
[Remedy] Contact our Customer Support Center.
842
Cause and Remedy
An error occurred in the USB memory device.
USB cable is connected correctly, and then switch on the machine power. If the error still
is not resolved, contact our Customer Support Center.
Failed to enter the Download mode.
An error occurred.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
An error occurred.
holding down both the <Start> and <Stop> buttons simultaneously for six seconds. This
deletes the print data that caused the error. If the error was caused by another reason,
switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
An error occurred.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
Job Based Accounting system started with no hard disk installed.
machine power, make sure that the touch screen is blank, and then switch on the
machine power to reset the operation.
An error occurred.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
An error occurred.