Fuji Xerox Versant 80 Press User Manual page 938

23 Appendix
Setting Item
Reduce/enlarge
23
2 Up mode
Output
destination
Tray 5
confirmation
Grid lines
938
Item Number
54 Sets the print magnification.
(Reduce/ [0] (Default) : Preset %
enlarge mode) [1]
[2]
[Preset %] is a magnification automatically calculated based on [Original
Size] and [Paper Size], and reduces/enlarges the printable area of the
document to fit in the printable area of the output paper. Therefore, if the
size of the document and of the output paper are identical, the ratio will be
100%. Also, if [2 Up] is selected, the document will be reduced to the size at
which two pages fit onto one sheet of paper.
[Variable %] is a magnification set in [Variable %] under [Reduce/Enlarge]. A
reference point for scaling (reducing/enlarging) is the upper left corner of the
printable area. This reference point applies to all text, images, and graphics.
[Fit to Cut Sheet] prints the entire cut sheet area onto the printable area of
the output paper. It is a magnification automatically calculated based on
[Original Size] and [Paper Size], and reduces/enlarges the entire document
(including the area outside of the printable area) to fit onto the printable
area of the output paper.
17 Sets the magnification for the vertical or horizontal direction.
(Variable %/ [45 to 210] (Default:100): 45-210%
vertical
Note
magnification)
18
(Variable %/
horizontal
magnification)
21 Sets whether to print with the 2 Up or page by page. 2 Up is a feature that
prints two pages onto one sheet of paper. Depending on the paper
orientation, the two pages are printed side by side, or one above the other.
[0] (Default) : Off
[1]
[2]
Important • When [Landscape] is selected for [Original Size], print result is identical for
9 Sets the output tray for the printouts.
[0] (Default) : Right Top Tray
[68]
[69]
[80]
[81]
67 Prints from Tray 5, after you instruct to print and then operate the machine
to start printing.
[0] (Default) : Off
[1]
22 Sets the method for printing double-byte grid lines. The options are as
follows.
[0] (Default) : Image
[1]
Value
: Variable %
: Fit to Cut Sheet
• When a continuous form paper is selected for [Original Size], print result is
identical for [Preset %] and [Fit to Cut Sheet].
: Forward
: Reverse
[Forward] and [Reverse].
:Stacker - Tray (optional)
:Stacker - Top Tray (optional)
: Right Middle Tray (optional)
: Right Top Tray (optional)
: On
: Font