Configuration Of Network Scanning (Job Template Scanning); Step 1 Preparations; Step 2 Enabling Ports And Setting Up Tcp/Ip - Fuji Xerox Versant 80 Press User Manual

17 Scanner Environment Settings

Configuration of Network Scanning (Job Template Scanning)

This section describes how to configure the machine to use the Network Scanning service.

Step 1 Preparations

The following environment is required to use the Network Scanning feature on the machine.
17

Step 2 Enabling Ports and Setting up TCP/IP

To use Network Scanning service, enable the port and set the IP address. The following
describes the configuration procedures on the machine.
Note
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
Note
3) Select [Tools] on the Services Home screen.
2
Enable the SNMP port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SNMP], and then select [Change Settings].
4) Select [Port Status], and select [Change Settings].
590
Step 1 Preparations..................................................................................................................................................................... 590
Step 2 Enabling Ports and Setting up TCP/IP ....................................................................................................................... 590
Step 3 Configuring the SNMP Port .......................................................................................................................................... 591
Step 4 Configuration on the Computer.................................................................................................................................. 591
To use SMB forwarding, your computer must run on one of the following operating
systems that supports folder sharing.
- Microsoft Windows Server 2003
- Microsoft Windows Server 2008
- Microsoft Windows Server 2008 R2
- Microsoft Windows Server 2012
- Microsoft Windows Server 2012 R2
- Microsoft Windows XP
- Microsoft Windows Vista
- Microsoft Windows 7
- Microsoft Windows 8
- Microsoft Windows 8.1
• You can configure the settings using CentreWare Internet Services. For information on how to use
CentreWare Internet Services, refer to "Configuring Machine Settings Using CentreWare Internet
Services" (P.558).
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
• The default user ID is "11111".
• The default passcode is "x-admin".