Port 9100 - Fuji Xerox DocuPrint 5105 d User Manual

Setting
Adobe Protocol Sets the PostScript communication protocol.
• [Normal] (default)
• [Binary]
• [TBCP]
• [RAW]
Note
• Select an appropriate option according to the data format specified on your print
• [Adobe Protocol] is enabled only when printing in PostScript.
• Normally, use this setting at its default [Normal].
PS Wait Timeout Sets the print waiting time for PostScript.
• [Disabled] (default)
• [Enabled]

[Port 9100]

Network/Port
Port 9100
Setting
Port Status
Sets whether to enable or disable the Port9100 port at printer start-up.
• [Enabled] (default)
• [Disabled]
Important
• If the printer runs out of memory when the port is enabled, the port is sometimes
Select this when the communication protocol is in ASCII format.
Select this when no special processing is required for data. Some data is printed
slower than with the [Normal] protocol.
Select this when the communication protocol is both in the ASCII and binary
formats, and switches between the two using control codes.
Select this when the communication protocol is in Raw format. Select this item
when EPS files cannot be printed properly from Macintosh computers using a
USB interface.
driver.
[Auto Eject Time] of [USB] is used.
[PS Wait Timeout] for PostScript print driver is used.
Port 9100
Port Status
Port 9100
Print Mode
Port 9100
PJL
Port 9100
Connect Time-Out
Port 9100
Port Number
Port 9100
TBCP Filter
automatically disabled. If this happens, either disable unused ports, or change
the memory allocation under [Allocate Memory].
Description
Description
5.2 Common Menus Setting
155