Fuji Xerox DocuPrint 5105 d User Manual page 105

Item Setting
Services > Receiving
E-mail > Protocol
Defaults >
Incoming Mail
From
Print Options
Address > Edit
Print Delivery
Confirmation E-
mail
Connectivity > IP Address /
Protocols > Host Name &
POP3 Setup Port
POP Receive
Password
Encryption
Login Name
Password
Polling Interval
Description
Specify the e-mail receiving
protocol.
Configure this setting when
printing the e-mail header
and message along with the
document attached to
received e-mail. Specify
[Attachment, Full Headers &
Message] to print the receive
routing of the e-mail, etc.
Specify whether or not
delivery receipt e-mail
should be printed.
Specify the IP address of the
POP3 server for receiving e-
mail, the IPv6-addr format,
or FQDN (Fully Qualified
Domain Name).
Specify the port number
used by the POP3 server.
Select the [APOP
Authentication] check box to
use APOP for POP receive
verification.
Set the login user name for the
POP3 server. Only one user can
be specified.
Specify the password for the
POP user name, and re-enter
the same password into
[Retype Password].
Specify the interval for
polling the POP3 server for
mail.
3.12 Printing Using E-mail - Mail Print -
Available Receiving Protocol
Settings
SMTP
• SMTP
• POP3*
• Print
Attachment
Only
• Print
Attachment &
Message if it
exists
• Attachment,
Basic Headers
& Message*
• Attachment,
Full Headers
& Message
• Off*
• On
• Print when
delivery fails
Alphanumeric
characters plus
period (.) and
hyphen (-); up to -
128 bytes
1 ~ 65535
• Cleared:
Disabled*
-
• Selected:
Enabled
ASCII graphic
characters (codes
-
33 to 126); up to
64 bytes
ASCII printable
characters
(ASCII graphic
characters plus -
space; codes 32
to 126); up to
64 bytes
1 to 120
minutes -
10 minutes*
POP3
-
-
105