Hardware Installation - Black Box LE3840A Manual

ETHERNET PRINT SERVERS HIGH SPEED AND 4-PORT

3.4 Hardware Installation

Use the following steps to connect the network and devices, such as printers,
plotters, or minicomputers, to the Ethernet Print Server.
1. Connect the Ethernet Print Server to the network.
2. Connect the parallel printer(s).
3. Connect devices to the Uniport.
Do not connect the Ethernet Print Server's power supply until ALL
hardware installation and software configuration steps are completed.
S 1: C
TEP ONNECT THE
You can connect the network in one of two ways:
• Using the 10BASE-T Ethernet interface. The 10BASE-T network
connection uses a
4-wire twisted pair RJ cable to plug into the RJ-45 network connector
(marked 10BASE-T on the back panel) on the Ethernet Print Server.
Once you make the connection, you are finished with this step.
Go to Step 2.
14
N
ETWORK TO THE
Fig. 3-2. 10BASE-T Connection.
E P
THERNET RINT
1 0 B A S E
- T
S
ERVER