Black Box LE3840A Manual page 80

CHAPTER 5: AppleTalk Configuration and Administration Program
When you choose this item on the Ethernet Print Server menu, the
following screen appears:
Turn on protocols
you want to use
(Ethernet Print
Server users are
limited to 2). Turn
off protocols not in
use.
Enter the IP
Address and
Subnet Mask
values for TCP/IP.
You must do this if
you could not
configure TCP/IP
to a rarp server.
After you select your protocols, be sure that you power the printer off
and on to accept the selections made. Changes will not occur if the
Ethernet Print Server is not recycled.
Options
Options is used to enable or disable displaying the Power-on Status Page
when you do not have access to Novell NetWare. When enabled, the
power-on status page prints after the printer attached to the Ethernet
Print Server is turned on. The default is the on position.
Protocol On Off
Netware
TCP/IP
Vines
DEC Lat
Cancel
Enter the value for the Default Gateway. This value enables
Ethernet Print Server to communicate with other Subnets.
Fig. 5-8. Protocol Setup.
NOTE
Protocol Setup
IP Address:
Subnet Mask:
Default Gateway:
OK
79