Black Box LE3840A Manual page 113

ETHERNET PRINT SERVERS HIGH SPEED AND 4-PORT
The error page shown in Fig. 7-3 prints when you are unable to
communicate with any Novell file servers.
Ethernet Print Server Unit: 991354
--------------------------------------------------------------------------------------------------
This unit is unable to communicate with any Novell file servers. It has
received no response at all to any of its requests from servers.
The most likely problems are:
1. The unit is not connected to the network. Make sure the network
cable is plugged into the unit. You may want to test the network cable
by connecting a workstation to it.
2. The jumper that selects the network type is in the wrong position.
Turn off the printer power and open the Ethernet Print Server unit,
make sure the large jumper block marked JP1 is in the correct position.
Move it to position 'THIN' to select Thin Ethernet, or to position 'TP'
to select 10BASE-T. This jumper is only read when the Ethernet Print
Server unit is powered up, so the change will go into effect when the
Ethernet Print Server is powered up again.
This unit will automatically attempt to reconnect to the network until it
either succeeds or is powered down.
Fig. 7-3. Error Page.
112