Using Netware 4.0 - Black Box LE3840A Manual

CHAPTER 4: Novell NetWare Configuration and NIMANAGE Utility
4. Press <Esc> to exit the program and select Yes when prompted to save
changes. You can then exit the PCONSOLE function or make changes
to your configuration.
S 6: E
TEP THERNET
ON (N W
TO ET ARE
You need to enable encrypted passwords by adding the statement below to
your AUTOEXEC.NCF file on the server using either the NetWare
INSTALL.NLM utility on the server or the NetWare SYSCON utility on a
workstation when logged in as supervisor. You can also type the statement
below at the server console (but when typed at the server console, it is not
permanent).
SET ALLOW UNENCRYPTED PASSWORDS=ON
Encrypted passwords do not work with the Print Server High Speed.
However, encrypted passwords are supported in the Print Server 4-Port.
Supporting Multiple File Servers
See Appendix D for information on supporting multiple file servers. This
includes information on passwords for multiple file servers assigned to the
print server.
When You Finish
Once you complete your PCONSOLE installation, go to the Hardware
Installation in Section 4.9.
4.4 Configuration—Using
NetWare 4.0
Novell NetWare 4.0 operates in two modes, Directory Services and Bindery
Services. You need to use Bindery mode for your Print Server configuration.
Directory Services mode allows users to log onto one server in a multi-server
network and access all servers on the network transparently. Unlike earlier
NetWare versions 2.x and 3.x which did not offer Directory Services, you need
only log onto the network once to access all servers.
However, in order for the Print Server to function properly with NetWare
4.0, it must be configured in PCONSOLE to use Bindery Services mode.
Once this is done, the Print Server will run as a Novell Print Server with all the
additional functionality of NetWare 4.0, since both modes run simultaneously
and transparently to each other.
P S H
RINT ERVER IGH
3. )
X AND ABOVE
S U : S
PEED SERS ET
U P
NENCRYPTED ASSWORDS
41